mount point Usage¶
Shows the percentage of disk space utilization for every mount point defined on the system. Having some of the mount points close to 100% space utilization is not good because of the risk of a “disk full” error that can block one of the services or even cause a crash of the entire system.
In cases where the mount point is close to 100% consider removing unused files or expanding the space allocated to the mount point.
Shows information about the disk space usage of the specified mount point.
Used is the amount of space used.
Free is the amount of space not in use.
Used+Free is the total disk space allocated to the mount point.
Having Free close to 0 B is not good because of the risk of a “disk full” error that can block one of the services or even cause a crash of the entire system.
In cases where Free is close to 0 B consider removing unused files or expanding the space allocated to the mount point.
Shows average latency for Reads and Writes IO Devices. Higher than typical latency for highly loaded storage indicates saturation (overload) and is frequent cause of performance problems. Higher than normal latency also can indicate internal storage problems.
Shows amount of physical IOs (reads and writes) different devices are serving. Spikes in number of IOs served often corresponds to performance problems due to IO subsystem overload.
Shows volume of reads and writes the storage is handling. This can be better measure of IO capacity usage for network attached and SSD storage as it is often bandwidth limited. Amount of data being written to the disk can be used to estimate Flash storage life time.
Shows how much disk was loaded for reads or writes as average number of outstanding requests at different period of time. High disk load is a good measure of actual storage utilization. Different storage types handle load differently - some will show latency increases on low loads others can handle higher load with no problems.
Disk IO Utilization¶
Shows disk Utilization as percent of the time when there was at least one IO request in flight. It is designed to match utilization available in iostat tool. It is not very good measure of true IO Capacity Utilization. Consider looking at IO latency and Disk Load Graphs instead.
Avg Disks Operations Merge Ratio¶
Shows how effectively Operating System is able to merge logical IO requests into physical requests. This is a good measure of the IO locality which can be used for workload characterization.
Disk IO Size¶
Shows average size of a single disk operation.
Get expert help¶
If you need assistance, visit the community forum for comprehensive and free database knowledge, or contact our Percona Database Experts for professional support and services.